Home Blog Certs Knowledge Base About
Q442 (none)

What uses HTTP messages to transfer data to applications residing on different hosts?

A OpenFlow
B OpenStack
C OpFlex
D REST
Q443 (none)

When a WLAN with WPA2 PSK is configured in the Wireless LAN Controller GUI which format is supported?

A Unicode
B base64
C decimal
D ASCII
Q444 (none)

Which 802.11 management frame type is sent when a client roams between access points on the same SSID?

A Reassociation Request
B Probe Request
C Authentication Request
D Association Request
Q446 (none)

What is a characteristic of private IPv4 addressing?

A traverse the Internet when an outbound ACL is applied
B issued by IANA in conjunction with an autonomous system number
C composed of up to 65.536 available addresses
D used without tracking or registration
Q447 (none)

Refer to the exhibit. Which command must be executed for Gi1.1 on SW1 to become a trunk port if Gi1/1 on SW2 is configured in desirable or trunk mode?

Question diagram
A switchport mode trunk
B switchport mode dot1-tunnel
C switchport mode dynamic auto
D switchport mode dynamic desirable
Q448 (none)

What are two improvements provided by automation for network management in an SDN environment? (Choose two)

Choose 2 — select all that apply
A Data collection and analysis tools establish a baseline for the network
B Artificial intelligence identifies and prevents potential design failures.
C Machine learning minimizes the overall error rate when automating troubleshooting processes
D New devices are onboarded with minimal effort
E Proprietary Cisco APIs leverage multiple network management tools.
Q449 (none)

An engineer must configure the IPv6 address 2001:0db8:0000:0000:0700:0003:400F:572B on the serial0/0 interface of the HQ router and wants to compress it for easier configuration. Which command must be issued on the router interface?

A ipv6 address 2001:db8::700:3:400F:572B
B ipv6 address 2001:db8:0::700:3:4F:572B
C ipv6 address 2001:Odb8::7:3:4F:572B
D ipv6 address 2001::db8:0000::700:3:400F:572B
Q450 (none)

Which WLC port connects to a switch to pass normal access-point traffic?

A redundancy
B console
C distribution system
D service
Q451 (none)

An engineering team asks an implementer to configure syslog for warning conditions and error conditions. Which command does the implementer configure to achieve the desired result? A. logging trap 5

B logging trap 2
C logging trap 4
D logging trap 3
Q452 (none)

Which two protocols are supported on service-port interfaces? (Choose two.)

Choose 2 — select all that apply
A RADIUS
B TACACS+
C SCP
D Telnet
E SSH